Multiple-well monitoring site adjacent to the Midway- Sunset and Buena Vista Oil Fields, Kern County, California

Groundwater quality in and around oil fields in the Southern San Joaquin Valley is of interest to many California residents that rely heavily on groundwater for domestic, commercial, and agricultural use. To help assess the effects of historical oil-field activities and natural geologic sources on groundwater near the southwest margins of the Kern County Groundwater Subbasin, a multiple-well monitoring site was installed near the administrative boundary between the Midway-Sunset and Buena Vista Oil Fields in Kern County, California. The installation of the Midway-Sunset Buena Vista multiple-well monitoring site (MSBV) supports regional analysis of the relations of oil and gas sources to groundwater quality by providing information about the geology, hydrology, geophysical properties, and water quality of the alluvial and upper Tulare aquifers in areas where groundwater data were limited. Data collected from the site included drill cuttings, whole core samples, sidewall core samples, mud-gas analysis, borehole geophysical logs, depth to water measurements, and water quality samples. Whole cores were scanned using dual energy computed tomography. Subsamples of selected cores were analyzed for density, porosity, specific retention, and bulk minerology. Thin sections of the subsamples were prepared, photographed, and examined. Two samples were analyzed using scanning electron microscope technology to examine the microporosity of diatomite laden sediment. Instrumentation installed in the wells collect hourly depth to water measurements.
Analysis of the data show there is 355 feet of alluvium overlying the Tulare Formation at the well site. The contact between the two formations is an aquitard resulting in a perched aquifer in the alluvium and unconfined aquifer in the Tulare Formation. The alluvium is more heterogenous and finer grained than the Tulare Formation resulting in markedly higher porosity in the alluvium compared to the Tulare Formation. Higher specific retention observed in the alluvium is attributed to the finer grained sediment and greater abundance of reworked diatomite (as represented by opal-CT [cristobalite-tridymite]) compared to the Tulare Formation. Total dissolved solids (TDS) approached or exceeded 10,000 milligrams per liter (mg/L) in the alluvium from approximately 176 to 242 feet below land surface and at the top of the Amnicola clay at approximately 670 feet below land surface within the Tulare Formation. Elevated TDS, chloride, and boron concentrations in the alluvium and on top of the Amnicola clay likely reflect groundwater that is mixed with oil-field water. Water chemistry and modern-aged groundwater in the alluvial monitoring well (MSBV #3) are consistent with the oil-field water in the alluvium being derived from documented historical surface disposal of oil-field water upslope (northwest) of the site. Water chemistry and pre-modern groundwater age in the deeper Tulare monitoring well (MSBV #1) on top of the Amnicola clay are consistent with oil-field fluids derived from upslope natural geologic sources or old oil wells that leak in the subsurface. Shallow groundwater in the Tulare (MSBV #2) is not affected by mixing with oil-field sources.