Near-surface material and topography generate anomalous high-frequency ground motion amplification in Chugiak, Alaska

An ∼3 km long nodal array oriented approximately east–west was deployed in Chugiak, Alaska, by the U.S. Geological Survey during 2021. The array intersects with the permanent NetQuakes station NP.ARTY, where peak ground acceleration (PGA) value of 1.98g was recorded during the 2018  M_w 7.1 Anchorage, Alaska, earthquake, in sharp contrast to the PGA of ∼0.3g at a site just 4 km to the west. Seismic data for M_w  1.8–4.3 aftershocks from the M_w  7.1 event recorded by the nodal array confirm the anomalously large ground motions obtained at NP.ARTY as well as similar amplifications at nodes within ∼1 km to the east. Here, we performed 0–10 Hz 3D finite‐difference simulations, including high‐resolution surface topography, to explore the cause of the unexpectedly large amplification. As expected, the simulations computed with a regional 3D tomography velocity model severely underpredict the 0–10 Hz acceleration records at almost all sites. Adding a near‐surface low‐velocity taper to 300 m depth amplifies the accelerations by up to a factor of 5 and enables a reasonable match between the nodal data and simulations at sites to the west of NP.ARTY. However, this model still underpredicts the spectral energy in the area covered by glacial sediments by up to an order of magnitude. The addition of a till layer using a depth‐dependent shear‐wave velocity (⁠⁠V_s) profile along with a homogeneous, 8 m thick low‐velocity layer with V_s = 250 m/s representing the kame terraces improves the fit to data to within a factor of 2 at nodes located on top of the glacial sediments. Our study shows that the anomalously large high‐frequency amplification recorded at and near NP.ARTY can be explained by a combination of topographic effects and near‐surface low‐velocity material with amplification effects on the high‐frequency ground motion by up to about 40% and an order of magnitude, respectively.