Yellowstone Lake Earthquake Swarm Summary
Seismic activity at Yellowstone Lake in Yellowstone National Park increased in late December 2008. As of January 8, 2009, the seismic activity has markedly decreased.
The swarm has ended; although a return of activity may occur as previous Yellowstone swarms of this size have lasted for tens of days to many weeks. Swarms are common at Yellowstone. The last notable swarm occurred in 2004, please see our 2004 article, Yellowstone Earthquake Swarms for more background information on earthquakes and swarms at Yellowstone.
Seismologists continue to review the earthquakes
About 900 earthquakes occurred between Dec. 26, 2008 and Jan. 8, 2009 in the Yellowstone Lake area. Five hundred of the earthquakes (including all greater than magnitude 2.0) have been reviewed by seismologists. There were 111 earthquakes with magnitudes greater than 2.0 (> M2.0) and 18 earthquakes > M3.0. As of Jan. 8, 2009, 400 smaller earthquakes have yet to be reviewed. The largest earthquake during the swarm was a magnitude 3.9 on Sunday, December 28, 2008. One of the analyses seismologists use to talk about earthquakes and swarms is the cumulative seismic moment, which is a measure of the earthquake energy. The cumulative moment (the energy from all the analyzed earthquakes in the swarm) for the Yellowstone Lake Swarm is equal to the energy of a single magnitude 4.5 earthquake (see Image 3).
Depths for shallow earthquake hypocenters (the point within the earth where an earthquake rupture starts) are difficult to determine accurately unless the seismic stations are spaced much more closely than those in the Yellowstone Seismic Network. The best located earthquakes have hypocenters (depths) of 3 to 10 km (1.8 to 6.0 miles). From Dec. 26 through Jan 2, the hypocenters appear to have migrated northwards, starting southeast of near Stevenson Island, with many of the latest events occurring near Fishing Bridge.
Swarms are Normal at Yellowstone
The recent swarm is well above typical activity at Yellowstone. Nevertheless it is not unprecedented during the last 40 years of monitoring. Earthquake swarms within the Yellowstone caldera are typical, with magnitudes occasionally ranging above 4.0. The 1985 swarm on the northwest rim of the caldera lasted for three months, with earthquakes up to M4.9 and over 3000 total events recorded.
The magnitudes of earthquakes in this swarm range from zero to 3.9. Earthquakes with magnitudes less than 3.4 are generally not felt by people unless they are very shallow and you are standing very close to the epicenter (point on the earth's surface above the hypocenter). For perspective, earthquakes of magnitude 3.4 to 4.5 are often felt and there were multiple reports of felt earthquakes during this swarm. A magnitude 5 or greater is generally required to produce damage to buildings or other structures.
New Equipment Allowed Monitoring of the Swarm
Improved volcano and seismic monitoring at Yellowstone gives us a greater ability to locate earthquakes, understand their source process and identify anomalous sources of seismic activity. New equipment including precise measurements of ground motion by GPS receivers and borehole strainmeters provided by the National Science Foundation's EarthScope and Continental Dynamics Program have been used extensively during the last week of intense earthquake activity. Ground motions accompanying the swarm, from the GPS instruments will take two or more weeks to fully process. It is worth noting that in 2004 the Yellowstone caldera began a period of accelerated uplift measured by GPS instruments that was as large as 7 cm/yr (2.7 inches/yr), three times as fast as recorded in the recorded history but has now reduced to about a maximum rate of 4 cm/yr. Scientists have modeled this deformation as due to magmatic recharge of the Yellowstone magma chamber at a depth of ~10 km (6 miles). The area of the swarm is on the eastern side of the uplift area. For more information on the uplift, please see our article Recent Ups and Downs of the Yellowstone Caldera.
There are Several Causes for Earthquakes
Earthquakes at Yellowstone are caused by a combination of geological factors including: 1) regional stress associated with normal faults (those where the valleys go down relative to the mountains) such as the nearby Teton and Hebgen Lake faults, 2) magmatic movements at depth (>7 kms or 4 miles), and 3) hydrothermal fluid activity caused as the groundwater system is heated to boiling by magmatic heat.
We Continue to Monitor Yellowstone Volcano
YVO staff from the USGS, University of Utah and Yellowstone National Park continue to carefully review all data streams that are recorded in real-time. As of 2009, there is no reason to believe that magma has risen to a shallow level within the crust or that a volcanic eruption is likely. The USGS Volcano Alert Level and Aviation Color Code for Yellowstone remain at Normal and Green.
The Yellowstone Volcano Observatory (YVO) is a partnership of the U.S. Geological Survey (USGS), Yellowstone National Park, and University of Utah to strengthen the long-term monitoring of volcanic and earthquake unrest in the Yellowstone National Park region. Yellowstone is the site of the largest and most diverse collection of natural thermal features in the world and the first National Park. YVO is one of the five USGS Volcano Observatories that monitor volcanoes within the United States for science and public safety.
Get Our News
These items are in the RSS feed format (Really Simple Syndication) based on categories such as topics, locations, and more. You can install and RSS reader browser extension, software, or use a third-party service to receive immediate news updates depending on the feed that you have added. If you click the feed links below, they may look strange because they are simply XML code. An RSS reader can easily read this code and push out a notification to you when something new is posted to our site.