Analysis of vertical flow during ambient and pumped conditions in four monitoring wells at the Pantex Plant, Carson County, Texas, July-September 2008

The Pantex Plant is a U.S. Department of Energy/National Nuclear Security Administration (USDOE/NNSA)-owned, contractor-operated facility managed by Babcock & Wilcox Technical Services Pantex, LLC (B&W Pantex) in Carson County, Texas, approximately 17 miles northeast of Amarillo. The U.S. Geological Survey, in cooperation with B&W Pantex through the USDOE/NNSA, made a series of flowmeter measurements and collected other borehole geophysical logs during July–September 2008 to analyze vertical flow in screened intervals of four selected monitoring wells (PTX01–1012, PTX06–1044, PTX06–1056, and PTX06–1068) at the Pantex Plant. Hydraulic properties (transmissivity values) of the section of High Plains (Ogallala) aquifer penetrated by the wells also were computed. Geophysical data were collected under ambient and pumped flow conditions in the four monitoring wells. Unusually large drawdowns occurred at two monitoring wells (PTX06–1044 and PTX06–1056) while the wells were pumped at relatively low rates. A decision was made to redevelop those wells, and logs were run again after redevelopment in the two monitoring wells.

Logs collected in monitoring well PTX01–1012 during ambient conditions indicate a dynamic environment that probably was affected by pumping of nearby irrigation or public-supply wells. During pumping, downward vertical flow of 0.2 to 2.1 gallons per minute that occurred during ambient conditions was either reversed or reduced. During pumping, a gradual trend of more positive flowmeter values (upward flow) with distance up the well was observed. Estimated total transmissivity for four production zones identified from Flow–B numerical model results taken together was calculated to be about 3,100 feet squared per day.

Logs collected in monitoring well PTX06–1044 during ambient conditions before redevelopment indicate a static environment with no flow. During pumping there was upward vertical flow at rates ranging from 0.1 to about 1.5 gallons per minute. During pumping, a gradual trend of more positive flowmeter values (upward flow) with distance up the well was observed. Estimated total transmissivity before redevelopment for five production zones identified from Flow–B numerical model results, and transmissivity values for each zone, are considered to be in error because of the lack of communication between the well and the aquifer before redevelopment. After redevelopment, logs for well PTX06–1044 during ambient conditions indicate a near-static environment with minimal downward flow. During pumping there was upward vertical flow at rates ranging from 0.5 to about 4.8 gallons per minute. During pumping, a gradual trend of more positive flowmeter values with distance up the well was observed. Estimated total transmissivity after redevelopment for the same five identified production zones taken together was calculated to be about 520 feet squared per day.

Logs collected in monitoring well PTX06–1056 during ambient conditions before redevelopment indicate a static environment with no flow. During pumping there was upward vertical flow at rates ranging from 0.3 to about 1.5 gallons per minute. During pumping, a gradual trend of more positive flowmeter values (upward flow) with distance up the well was observed. Estimated total transmissivity before redevelopment for four production zones identified from Flow–B numerical model results taken together was calculated to be about 450 feet squared per day. After redevelopment, logs collected in monitoring well PTX06–1056 during ambient conditions indicate a near-static environment with no flow except for a very small amount of downward flow near the bottom of the well. During pumping there was upward vertical flow at rates ranging from 0.7 to about 2.9 gallons per minute. Estimated total transmissivity after redevelopment for five production zones identified from Flow–B numerical model results taken together was calculated to be about 330 feet squared per day.

Logs collected in monitoring well PTX06–1068 during ambient conditions indicate a static environment with no flow. During pumping there was upward vertical flow at rates ranging from 0.4 to 4.8 gallons per minute. During pumping, a gradual trend of more positive flowmeter values (upward flow) with distance up the well was observed. Estimated total transmissivity for four production zones identified from Flow–B numerical model results taken together was calculated to be about 200 feet squared per day.