Earthquake stress drop, source spectra from laboratory experiments, and the apparent unsteadiness of frictional slip

Over a range of co-seismic total energy release, high sample rate slip, stress, and slip velocity measurements were made during frictional failure to determine seismic source properties. The near-field measurements were used to estimate stress drops using spectral approaches that are analogous to the standard seismological moment-corner determined Δσ and acceleration amplitude Δσ_arms stress drops. Rapid frictional sliding produces slip velocity amplitude spectra that vary with frequency^-1 so long as the energy dissipated by friction approaches the total energy release. Under these conditions Δσ and Δσ_arms are similar in size. Since these are nearly direct measurements of fault slip velocity and because they produce flat acceleration spectra between the corner and an apparent fmax, friction in these experiments seems to produce dynamic acceleration and deceleration at all resolved frequencies. The physical origin of this unsteady motion is not known exactly but likely reflects rapid dynamic variations in fault strength or applied stress. On the other hand, when the total energy stored prior to failure is artificially made somewhat larger relative to that which can be dissipated by friction the velocity spectra vary with frequency^-2 immediately below the corner. At these conditions Δσ and Δσ_arms diverge. The excess stored energy is preferentially partitioned into radiated energy upon failure. Collectively the experiments imply that to produce unsteady, white noise accelerations that are observed for natural earthquakes, requires that at least 95% of the energy released does not escape the source region to be radiated to the far-field.