Skip to main content
U.S. flag

An official website of the United States government

Volcano Watch - 7 months of no lava at Pu‘u ‘Ō‘ō heralds end of an era

January 31, 2019

One of the most frequent questions asked of USGS Hawaiian Volcano Observatory (HVO) scientists the last several months has been, “Is the lower East Rift eruption over?” But the same question could – and should – be asked of the Pu‘u ‘Ō‘ō eruption.

On January 3rd, 2018, we marked the 35th anniversary of Pu‘u ‘Ō‘ō. For the past three and a half decades, lava has erupted almost continuously from the middle East Rift Zone (ERZ). Minor pauses in surface activity mostly occurred between the fountaining episodes in 1983 – 1986, and subsequently during a few episodes marked by subsidiary fissures, intrusions, or partial crater floor collapses.

Given the longevity of the Pu‘u ‘Ō‘ō eruption, we’d grown accustomed to the luxury of having nearly-uninterrupted access to lava. The lure of reliable lava viewing beckoned to millions of tourists around the globe.

But, I say “nearly-uninterrupted” because there have been over one hundred brief pauses in surface activity throughout the 35-year-long event, most lasting hours to a couple days. The six longest pauses during the Pu‘u ‘Ō‘ō activity were each 1 to 2-months-long, and all occurred between fountaining episodes in the first two years.

Specifically, long pauses between fountains occurred spanning episodes 3 and 4 (65 days), episodes 32 and 33 (52 days), episodes 12 and 13 (50 days), episodes 39 and 40 (49 days), episodes 25 and 26 (43 days), and episodes 31 and 32 (38 days).

After the fountaining episodes, there were several Pu‘u ‘Ō‘ō eruption pauses lasting between one week and one month.

Specifically, there was a 10 day pause in February of 1992 after the Kupaianaha vent shut down, ending episodes 48. A year later there was an eight day pause in February of 1993 after an uprift intrusion cause Pu‘u ‘Ō‘ō’s crater floor to collapse. A nine day pause in February of 1996 occurred after an observed surge in effusion rate.

The longest eruption hiatus after the fountaining phase lasted 24 days following the episode 54 fissure in Nāpau Crater in February of 1997. In September 1999, there was an 11-day pause during episode 55 after a partial collapse of the Pu‘u ‘Ō‘ō crater floor.

Most recently, there were two pauses in 2011: an 18-day-long pause after the March Kamoamoa fissure, and a six day long pause after the episode 60 west flank break out in August.

However, on April 30th, 2018 – everything changed. The catastrophic collapse of Pu‘u ‘Ō‘ō has left the iconic eruption site and surrounding lava flow fields devoid of lava through the rest of 2018. December 30th marked the seven month anniversary of no surface activity at Pu‘u ‘Ō‘ō and is effectively a concluding milestone for this long-lived event.

As a refresher from our previous article, the Smithsonian Institution’s Global Volcanism Program (GVP) (https://volcano.si.edu/) classifies the end of continuous volcanic activity based on an absence of eruptive activity over a 90 day (three month) period.

Statistically, after a 210 day (7 month) gap in activity, it is extremely unlikely that lava will resume activity within Pu‘u ‘Ō‘ō. Based on historical knowledge of rift zone eruptions, pauses lasting more than 3½ months have ended their respective eruption.

Given the GVP criterion, no signs of imminent unrest, and that December 30th, 2018 marks 7 months of no lava, then the Pu‘u ‘Ō‘ō eruption could be considered over. The 36th anniversary of continuous eruption, on January 3, 2019, will not come to pass.

This does not mean Kīlauea Volcano is dead. New eruptions have previously begun elsewhere on Kīlauea after months to decades of quiet. Magma is being supplied to the volcano, and deformation data shows evidence for movement of molten rock through the magmatic system, refilling the middle ERZ. It’s important to note that Kīlauea is still an active volcano that will erupt in the future, and associated hazards have not changed. When a new eruption does occur, ground cracking, gas emissions, seismicity, and deformation can increase rapidly.

The USGS Hawaiian Volcano Observatory continues to closely monitor Kīlauea Volcano through ground-based observations, helicopter overflights, and geophysical instrument networks. Significant changes will be noted in HVO’s weekly updates.
 

helicopter overflight
Pu‘u ‘Ō‘ō on May 3, 2018, as viewed from the helicopter overflight. The crater floor is collapsed, and a thin plume escapes from the gaping crater. The west flank cracked on April 30th around 2:30 pm HST, and minor amounts of lava oozed out of the crack (line of steaming features) just before the plumbing system catastrophically failed.

Volcano Activity Update

Kīlauea is not erupting. Rates of seismicity, deformation, and gas release have not changed significantly over the past week.

There was 1 event with 3 or more felt reports in the Hawaiian Islands during the past week. On January 27, 2019 at 08:24 a.m. HST, a magnitude-3.5 earthquake occurred in the upper Southwest Rift Zone of Mauna Loa at a depth of -0.5 km (0.3 mi above sea level).

Deformation signals are consistent with refilling of the middle ERZ. Sulfur dioxide emission rates have been below detection limits in the lower ERZ since early September, though minor amounts of volcanic gas are still present.

Hazardous conditions still exist at both the lower ERZ and summit. Residents in the lower Puna District and Kīlauea summit areas on the Island of Hawai‘i should stay informed and heed Hawai‘i County Civil Defense closures, warnings, and messages (http://www.hawaiicounty.gov/active-alerts).

The USGS Volcano Alert level for Mauna Loa remains at NORMAL.

Get Our News

These items are in the RSS feed format (Really Simple Syndication) based on categories such as topics, locations, and more. You can install and RSS reader browser extension, software, or use a third-party service to receive immediate news updates depending on the feed that you have added. If you click the feed links below, they may look strange because they are simply XML code. An RSS reader can easily read this code and push out a notification to you when something new is posted to our site.