The Albuquerque Basin, located in central New Mexico, is about 100 miles long and 25–40 miles wide. The basin is hydrologically defined as the extent of consolidated and unconsolidated deposits of Tertiary and Quaternary age that encompasses the structural Rio Grande Rift between San Acacia to the south and Cochiti Lake to the north. A 20-percent population increase in the basin from 1990 to 2000 and a 22-percent population increase from 2000 to 2010 resulted in an increased demand for water in areas within the basin. Drinking-water supplies throughout the basin were obtained primarily from groundwater resources until December 2008, when the Albuquerque Bernalillo County Water Utility Authority (ABCWUA) began treatment and distribution of surface water from the Rio Grande through the San Juan-Chama Drinking Water Project.
An initial network of wells was established by the U.S. Geological Survey (USGS) in cooperation with the City of Albuquerque from April 1982 through September 1983 to monitor changes in groundwater levels throughout the Albuquerque Basin. In 1983, this network consisted of 6 wells with analog-to-digital recorders and 27 wells where water levels were measured monthly. As of water year 2021, the network consisted of 120 wells and piezometers at 54 locations. The USGS, in cooperation with the ABCWUA, the New Mexico Office of the State Engineer, and Bernalillo County, measures water levels at the wells and piezometers in the network; this report, prepared in cooperation with the ABCWUA, presents water-level data collected by USGS personnel at the sites through water year 2021 (October 1, 2020, through September 30, 2021). Water-level data that were collected in previous water years from wells that were later discontinued were published in previous USGS reports.
