David Wilson

Replacement or deterioration of seismic instruments and the evolution of the installation conditions and sites can alter the seismic signal in very subtle ways, so it is notoriously difficult to monitor the signal quality of permanent seismic stations. We present a simple tool, energy ratios between each pair of the three recorded components, aimed at characterizing and monitoring signal...

World‐Wide Standardized Seismograph Network (WWSSN) records contain daily calibration pulses that can be used to retrieve the magnification as well as the response of the instrument for a given day record. We analyze a select number of long‐period vertical (LPZ) records from WWSSN station ALQ (Albuquerque, New Mexico). Although we find that the response of this instrument varies widely...

Station noise levels play a fundamental limitation in our ability to detect seismic signals. These noise levels are frequency-dependent and arise from a number of physically different drivers. At periods greater than 100 s, station noise levels are often limited by the self-noise of the instrument as well as the sensitivity of the instrument to non-seismic noise sources. Recently...

Seismic station data quality is commonly defined by metrics such as data completeness or background seismic noise levels in specific frequency bands. However, for temporary networks such as aftershock deployments or induced seismicity monitoring, the most critical metric is often how well the station performs when recording events of interest. A timely measure of station performance can...

By coupling with the ground, wind causes ground motion that appears on seismic records as noise across a wide bandwidth. This wind-generated noise can drown out important features such as small earthquakes and prevent observation of normal modes from large earthquakes. Because the wind field is heterogeneous at local scales due to structures, diurnal heating, and topography, wind-induced...

Long-period Rayleigh wave horizontal to vertical amplitude (H/V) ratios at a station provide information about local earth structure that is complementary to phase velocity. However, a number of studies have observed that significant scatter appears in these measurements making it difficult to use H/V ratio measurements to resolve earth structure. Some of the scatter in these...

The Albuquerque Seismological Laboratory (ASL) has preserved a collection of photographs of seismographic equipment, stations, and drawings used by the United States Coast and Geodetic Survey (USC&GS) in the early-to-mid-twentieth century. The photographs were transferred to ASL from the US Department of Commerce building in Washington DC after ASL became established as a USC&GS facility...

From 1961 to 1996, the Albuquerque Seismological Laboratory (ASL) installed and operated the World‐Wide Standardized Seismograph Network (WWSSN). Each station within the network consisted of three Benioff short‐period sensors and three Sprengnether Press‐Ewing long‐period sensors along with recording, timing, and calibration equipment. Approximately 3.7 million single‐day record film...

Seismologists have recently begun utilizing low-cost nodal sensors in dense deployments to sample the seismic wavefield at unprecedented spatial resolution. Earthquake Early Warning Systems (EEWS) and other monitoring networks (e.g. wastewater injection) would additionally benefit from network densification; however, current nodal systems lack power systems and/or real-time data...

Characterizing rotational motions from earthquakes at local distances has the potential to improve earthquake engineering and seismic gradiometry by better characterizing the complete seismic wavefield. Applied Technology Associates (ATA) has developed a proto‐seismic magnetohydrodynamic (SMHD) three‐component rotational rate sensor. We deploy two ATA rotational rate sensors at a...

To standardize parameters used in seismometer testing and calibration and to make these algorithms accessible to the seismological community, we have developed a new seismometer testing software package called Albuquerque Seismological Laboratory (ASL) Sensor Test Suite. This software is written in Java and makes use of Seismological Exchange for Earthquake Data (SEED) format. Our goal...

The instruments installed at Global Seismographic Network (GSN) stations were designed to record Earth’s vibrations, but they sometimes pick up sound waves from unexpected sources. For example, newly installed infrasound sensors at a station on Puerto Rico recorded the passage of Hurricane Maria on 20 September 2017.