Publications

Hydraulic fracturing stress measurements and a borehole televiewer survey were conducted in a 1.6‐km‐deep well at Auburn, New York. This well, which was drilled at the outer margin of the Appalachian Fold and Thrust Belt in the Appalachian Plateau, penetrates approximately 1540 m of lower Paleozoic sedimentary rocks and terminates 60 m into the Precambrian marble basement. Analysis of...

In 1981, the United States Geological Survey recorded a seismic-refraction profile across the southern Santa Cruz Mountains in west-central California to examine the shallow velocity structure of this seismogenic region. This 40-km-long profile, which consisted of three shotpoints, extended northeastward from near Watsonville, California, to Coyote Lake, crossing the San Andreas, Sargent...

We have estimated the source parameters of 53 microearthquakes recorded in July 1983 which were aftershocks of the Miramichi, New Brunswick, earthquake that occurred on 9 January 1982. These events were recorded by local three-component digital seismographs at 400 sps/component from 2-Hz velocity transducers sited directly on glacially scoured crystalline basement outcrop. Hypocentral...

A 100×40 km trilateration network extending from Bishop, California, to near Hawthorne, Nevada, crosses the east end of the Long Valley caldera, site of renewed magma inflation in the 1979–1980 interval, and spans most of the White Mountain seismic gap. The network was surveyed in 1972, 1973, 1976, 1979, 1980, and 1982. The 1980 survey may be contaminated by a scale error. In addition...

The 1982–1983 deformation observed by trilateration and leveling surveys across the Long Valley caldera is apparently related to the 8.5‐km‐long by 8‐km‐deep vertical rupture surface defined by the January 1983 earthquake swarm that occurred in the south moat of the caldera. The observed deformation can be explained as follows. In late 1982, 0.03 km3 of magma was injected into a dike...

The Tehachapi trilateration network spans the intersection of the San Andreas and Garlock faults in southern California in the “Big Bend” region of the San Andreas fault. Analysis of data from 1973–1983 shows strain differences between the northwest and southeast regions of the network and slip at depth on both faults. The Palmdale network, spanning the San Andreas fault entirely within...

A 275‐km‐long reversed refraction profile in the Oregon Cascades, two shallow earthquakes of magnitude 5 in southern Washington, a shallow earthquake of magnitude 4.6 in northern California, and a previously published analysis of the Bouguer gravity field are used to develop a crustal P wave velocity model for the Oregon Cascades. Travel time analysis of the refraction profile indicates...

The U.S. Geological Survey conducted an extensive seismic refraction survey in the Imperial Valley region of California in 1979. The Imperial Valley is located in the Salton Trough, an active rift between the Pacific and North American plates. Forty shots fired at seven shot points were recorded by 100 portable seismic instruments at typical spacing of 0.5–1 km. More than 1300 recording...

The important role of pore pressure in promoting such brittle processes as cataclasis, hydraulic fracturing, large‐scale faulting, and earthquakes within the crust is widely accepted in geology and geophysics [, 1957; , 1959; , 1958; ., 1963; , 1968; ., 1968; ., 1976; , 1973, 1980; , 1981]. Provided that fluid pressure is fully communicated with rock pore space, the effective normal...

Crystallographically oriented single‐crystal prisms of gem quality topaz (composition AlSiO (OH− F) where x = 0.04 ± 0.01) were deformed at a confining pressure of 1.50 GPa, a temperature of 800°C, and a strain rate of 2×10 s. Under nearly identical conditions, all crystals of anhydrous rock‐forming minerals that have been tested to date, such as olivine, quartz, feldspars, pyroxenes...

A hydrothermally grown synthetic quartz crystal with 370±60 ppm hydroxyl impurity was cut into right rectangular prisms in eight crystallographic orientations. We compressed the prisms under constant axial force corresponding to a uniaxial stress of 140.0±0.5 MPa, and temperatures of 510° and 750°C. All but one of the samples sustained permanent axial strains of 2–3%. We established the...

No abstract available.