Publications

This chapter describes the exploration, development, and geologic setting of petroleum resources (including tar sands), coal resources (including coalbed methane), and geothermal energy resources of the Northern Cordillera.For petroleum resources, the chapter describes: (1) the history of petroleum development and production, first for Alaska and then for the Canadian Cordillera; and (2)

No abstract available.

The Yakima fold province, located in the backarc of the Cascadia subduction zone, is a region of active strain accumulation and deformation distributed across a series of fault-cored folds. The geodetic network in central Washington has been used to interpret large-scale N-S shortening and westward-increasing strain; however, geodetic data are unable to resolve shortening rates across...

The Eagle Ford shale is a major continuous oil and gas resource play in southcentral Texas and a source for other oil accumulations in the East Texas Basin. As part of the U.S. Geological Survey’s (USGS) petroleum system assessment and research efforts, a coring program to obtain several immature, shallow cores from near the outcrop belt in central Texas has been undertaken. The first of...

Low-temperature hydrous pyrolysis (LTHP) at 300°C (572°F) for 24 h released retained oils from 12- to 20-meshsize samples of mature Niobrara marly chalk and marlstone cores. The released oil accumulated on the water surface of the reactor, and is compositionally similar to oil produced from the same well. The quantities of oil released from the marly chalk and marlstone by LTHP are...

No abstract available.

Organic sulfur compounds are ubiquitous in natural oil and gas fields and moderate-low temperature sulfide ore deposits. Previous studies have shown that organic sulfur compounds are important in enhancing the rates of thermochemical sulfate reduction (TSR) reactions, but the details of these reaction mechanisms remain unclear. In order to assess the extent of sulfate reduction in the...

Weathered samples from naturally exposed outcrops of troctolite associated with a magmatic Ni-Cu sulphide deposit were characterized by synchrotron-based micro-X-ray fluorescence mapping (µ-XRF) and X-ray absorption spectroscopy (XAS), as well as by lab-based X-ray diffraction, electron microscopy, Raman spectroscopy and wet chemical methods. Metal mobility in weathered samples was...

Widespread deployment of carbon capture and storage (CCS) is likely necessary to be able to satisfy baseload electricity demand, to maintain diversity in the energy mix, and to achieve climate and other objectives at the lowest cost. If all of the carbon dioxide (CO2) emissions from stationary sources (such as fossil-fuel burning power plants, and other industrial plants) in the United...

Basin-wide datasets that provide information on the geochemical properties of petroleum systems, such as source rock quality, product composition, and thermal maturity, are often difficult to come by or assemble from publicly available data. When published studies are available and include these kinds of properties, they generally have few sampling locations and limited numbers and types...

Determining the chemical and mineralogical variability within fine-grained mudrocks poses analytical challenges but is potentially useful for documenting subtle stratigraphic differences in physicochemical environments that may influence petroleum reservoir properties and behavior. In this study, we investigate the utility of combining principal component analysis (PCA) of X-ray...

The U.S. Geological Survey (USGS) has conducted an assessment of water and proppant requirements, and water production volumes, associated with possible future production of undiscovered petroleum resources in the Bakken and Three Forks Formations, Williston Basin, USA. This water and proppant assessment builds directly from the 2013 USGS petroleum assessment for the Bakken and Three...