Publications

Global Navigation Satellite System data across the New Madrid seismic zone (NMSZ) in the central United States over the period from 2000 through 2014 are analyzed and modeled with several deformation mechanisms including the following: (1) creep on subsurface dislocations, (2) postseismic frictional afterslip and viscoelastic relaxation from the 1811–1812 and 1450 earthquakes in the NMSZ...

Northwest directed slip from the southern San Andreas Fault is transferred to the Mission Creek, Banning, and Garnet Hill fault strands in the northwestern Coachella Valley. How slip is partitioned between these three faults is critical to southern California seismic hazard estimates but is poorly understood. In this paper, we report the first slip rate measured for the Banning fault...

The central United States has undergone a dramatic increase in seismicity over the past 6 years (Fig. 1), rising from an average of 24 M≥3 earthquakes per year in the years 1973–2008 to an average of 193 M≥3 earthquakes in 2009–2014, with 688 occurring in 2014 alone. Multiple damaging earthquakes have occurred during this increase including the 2011 M 5.6 Prague, Oklahoma, earthquake...

Knowledge of the electrical properties of multicomponent systems with gas hydrate, sediments, and pore water is needed to help relate electromagnetic (EM) measurements to specific gas hydrate concentration and distribution patterns in nature. Toward this goal, we built a pressure cell capable of measuring in situ electrical properties of multicomponent systems such that the effects of...

Aftershocks may be driven by stress concentrations left by the main shock rupture or by elastic stress transfer to adjacent fault sections or strands. Aftershocks that occur within the initial rupture may be limited in size, because the scale of the stress concentrations should be smaller than the primary rupture itself. On the other hand, aftershocks that occur on adjacent fault...

A remarkable increase in seismic activity in Oklahoma since 2009 has been shown to correlate closely with enhanced hydrocarbon extraction and associated wastewater disposal; 99% of this recent Oklahoma earthquake activity has occurred within 15 km of a call II injection well (Ellsworth, 2013). In response to this increase in seismic activity, the U.S. Geological Survey (USGS) partnered...

Triggered seismicity arising from dynamic stresses is often explained by the Mohr-Coulomb failure criterion, where elevated pore pressures reduce the effective strength of faults in fluid-saturated rock. The seismic response of a fluid-rock system naturally depends on its hydro-mechanical properties, but accurately assessing how pore-fluid pressure responds to applied stress over large...

In a seismically active region, structures may be subjected to multiple earthquakes, due to mainshock–aftershock phenomena or other sequences, leaving no time for repair or retrofit between the events. This study quantifies the aftershock vulnerability of four modern ductile reinforced concrete (RC) framed buildings in California by conducting incremental dynamic analysis of nonlinear...

I present a long-term earthquake rate model for the central and eastern United States from adaptive smoothed seismicity. By employing pseudoprospective likelihood testing (L-test), I examined the effects of fixed and adaptive smoothing methods and the effects of catalog duration and composition on the ability of the models to forecast the spatial distribution of recent earthquakes. To...

The decay of the Fourier spectral amplitudes of S waves over distances of 10–80 km near Charlevoix, Quebec, was determined using waveforms from seven earthquakes with MN 3.3–5.4. The S‐wave spectral amplitudes were corrected for site response and source amplitude by normalizing the coda‐wave spectrum at a fixed time after the origin time. The amplitude decay with distance was found to be...

No abstract available.

No abstract available.