Publications

Often referred to as “mudflows,” debris flows are a type of landslide made up of a rapidly moving mixture of dirt, rocks, trees, and water (and sometimes ash) that start on a hillside and travel downvalley. They can easily overflow channels and severely damage houses, vehicles, or other structures. Areas burned by wildfires are especially susceptible to these hazards, which can be...

We present a model of the lower seismogenic depth of earthquakes in the western United States (WUS) estimated using the hypocentral depths of events M > 1, a crustal temperature model, and historical earthquake rupture depth models. Locations of earthquakes are from the Advanced National Seismic System Comprehensive Earthquake Catalog from 1980 to 2021 supplemented with seismicity in...

It has been nearly a decade since updates to seismic and fault sources in the central and eastern United States (CEUS) were last assessed for the 2012 Central and Eastern United States Seismic Source Characterization for nuclear facilities (CEUS-SSCn) and 2014 United States Geological Survey National Seismic Hazard Model (NSHM) for the conterminous U.S. In advance of the 2023 NSHM update...

A fault‐based crustal deformation model with deep driven dislocation sources is applied to estimate long‐term on‐fault slip rates and off‐fault moment rate distribution in the western United States (WUS) for the 2023 update to the National Seismic Hazard Model (NSHM). This model uses the method of Zeng and Shen (2017) to invert for slip rate and strain‐rate parameters based on inputs...

No abstract available.

No abstract available.

Prior studies have repeatedly shown that probabilistic seismic hazard maps from several different countries predict higher shaking than that observed. Previous map assessments have not, however, considered the influence of site response on hazard. Seismologists have long acknowledged the influence of near-surface geology, in particular low-impedance sediment layers, on earthquake ground...

Inversion of low-frequency regional seismic records to solve for a time series of bulk forces exerted on the earth by a landslide (a force-time function) is increasingly being used to infer volumes and dynamics of large, highly energetic landslides, such as rock avalanches and flowslides, and to provide calibration information on event dynamics and volumes for numerical landslide runout...

The U.S. Geological Survey (USGS) National Seismic Hazard Model (NSHM) is used in construction codes, such as the National Earthquake Hazard Reduction Program (NEHRP) Provisions, to develop ground motions for structural and geotechnical design. When the NSHM is updated (e.g. changes to its earthquake rupture forecast or ground motion models), or the manner in which it is implemented in

A variety of models exist for characterizing earthquake-induced ground failures, but application of these models towards regional seismic performance assessments of buried pipelines remains challenging. One challenge is that ground failures often occur at localized geospatial scales while buried pipelines are spatially distributed over long distances. In this study, we propose a...

We develop an empirical, spatially continuous model for the single-station within-event (ϕSS) component of earthquake ground motion variability in the Los Angeles area. ϕSS represents event-to-event variability in site response or remaining variability due to path effects not captured by ground motion models. Site-specific values of ϕSS at permanent seismic network stations were...

This paper presents a summary of the applicability of the NGA-West2 damping scaling factors to ground motions recorded in France. In developing ground motion models for response spectra, generally, the damping of the oscillator is set to a reference value of five percent of the critical damping. Damping scaling factors (DSF) are used to translate the predictions of 5%-damped ground...