Publications

The Seattle fault poses a significant seismic hazard to the city of Seattle, Washington. A hybrid, low-frequency, high-frequency method is used to calculate broadband (0-20 Hz) ground-motion time histories for a M 6.5 earthquake on the Seattle fault. Low frequencies (1 Hz) are calculated by a stochastic method that uses a fractal subevent size distribution to give an ω-2 displacement...

We introduce a quantitative approach to paleoearthquake dating and apply it to paleoseismic data from the Wrightwood and Pallett Creek sites on the southern San Andreas fault. We illustrate how stratigraphic ordering, sedimentological, and historical data can be used quantitatively in the process of estimating earthquake ages. Calibrated radiocarbon age distributions are used directly...

Near-surface site factors and the effects of deep structural focusing were estimated in the Santa Monica Mountains and Santa Monica, California, from a portable array of 75 seismic stations deployed during the Los Angeles Region Seismic Experiment, Phase II (LARSE II). The objective was to examine further the origin of seismic wave amplification in the region of intense damage south of...

The paucity of strong-motion stations near the 1999 Hector Mine earthquake makes it impossible to make instrumental studies of key questions about near-fault strong-motion patterns associated with this event. However, observations of displaced rocks allow a qualitative investigation of these problems. By observing the slope of the desert surface and the frictional coefficient between...

In May 1997, the US Geological Survey (USGS) and the University of Southern California (USC) acquired high-resolution seismic reflection and refraction images on the grounds of the Wadsworth Veterans Administration Hospital (WVAH) in the city of Los Angeles (Fig. 1a,b). The objective of the seismic survey was to better understand the near-surface geometry and faulting characteristics of...

The former George Air Force Base (GAFB), now known as the Southern California Logistics Airport (SCLA), is located in the town of Adelanto, approximately 100 km northeast of Los Angeles, California (Fig. 1). In this report, we present acquisition parameters, data, and interpretations of seismic images that were acquired in the OU-1 area of GAFB during July 1999 (Fig. 2). GAFB is...

Oil test wells can provide information on the depth, age, inclination, porosity, permeability, density, faulting, folding, and organic content of geologic formations mapped at the surface, or on units not recognized in surface outcrops. Formation density, as expressed in sonic and density logs commonly obtained when wells are drilled, has become increasingly important in making a crustal...

Geodetic satellites of the Global Positioning System (GPS) now permit continuous recording of surface motions around earthquake faults and volcanoes with millimeter precision. Data from distinct points on Earth's surface can be combined to infer the locations of the sources of deformation at depth in the crust. These data are radically altering our understanding of earthquake processes...

Recent earthquakes around the world show a pattern of steadily increasing damages and losses. The increases are due primarily to two factors: 1) significant growth in urban areas that are prone to earthquakes; and 2) the vulnerability of the older building stock, even buildings that were constructed within the past twenty years. In the United States, earthquake risk has grown...

No abstract available.

An important requirement for a comprehensive seismic monitoring system is the capability to accurately locate small seismic events worldwide. Accurate event location can improve the probability of determining whether or not a small event, recorded predominantly by local and regional stations, is a nuclear explosion. For those portions of the earth where crustal velocities are not well...

Seismic reflection and refraction images illuminate the San Andreas Fault to a depth of 1 kilometer. The prestack depth-migrated reflection image contains near-vertical reflections aligned with the active fault trace. The fault is vertical in the upper 0.5 kilometer, then dips about 70° to the southwest to at least 1 kilometer subsurface. This dip reconciles the difference between the...