Publications

Crustal-scale seismic-velocity models across the Denali fault zone along the Richardson Highway show a 50-km-thick crust, a near vertical fault trace, and a 5-km-wide damage zone associated with the fault near Trans-Alaska Pipeline Pump Station 10, which provided the closest strong ground motion recordings of the 2002 Denali fault earthquake. We compare models, derived from seismic...

Data from the 2002 Denali fault earthquake recorded at 26 sites in and near Anchorage, Alaska, show a number of systematic features important in studies of site response and in constructing long-period spectra for use in earthquake engineering. The data demonstrate that National Earthquake Hazards Reduction Program (NEHRP) site classes are a useful way of grouping stations according to...

No abstract available.

Regional seismic waveforms, continuous and campaign-mode GPS data, and surface slip measurements were used to obtain a kinematic model of the rupture process of the November 3, 2002 Mw 7.9 Denali, Alaska, earthquake. The event initiated as a Mw 7.0 reverse slip event on the north-dipping Susitna Glacier fault with subsequent right-lateral slip distributed over approximately 300 km of the...

A 66-monument geodetic array spanning the Coast Ranges near San Francisco has been surveyed more than eight times by GIPS between late 1993 and early 2001. The measured horizontal velocities of the monuments are well represented by uniform, right-lateral, simple shear parallel to N29°W. (The local strike of the San Andreas Fault is ∼N34°W.) The observed areal dilatation rate of 6.9 ± 10...

Seismic velocity and attenuation anomalies in the mantle are commonly interpreted in terms of temperature variations on the basis of laboratory studies of elastic and anelastic properties of rocks. In order to evaluate the relative contributions of thermal and non-thermal effects on anomalies of attenuation of seismic shear waves, Q−1s, and seismic velocity, Vs, we compare global maps of...

We report new strength data for the serpentine mineral chrysotile at effective normal stresses, σn between 40 and 200 MPa in the temperature range 25°-280°C. Overall, the coefficient of friction, μ (= shear stress/effective normal stress) of water-saturated chrysotile gouge increases both with increasing temperature and σn, but the rates vary and the temperature-related increases begin...

When raised to temperatures above the ice melting point, gas hydrates release their gas in well-defined, reproducible events that occur within self-maintained temperature ranges slightly below the ice point. This behavior is observed for structure I (carbon dioxide, methane) and structure II gas hydrates (methane-ethane, and propane), including those formed with either H2O- or D2O-host...

Peels made from 10 geoslices beneath a riverbank at Washington's Hunting Island, 45 km inland from the Pacific coast, aid in identifying sand that liquefied during prehistoric earthquakes of estimated magnitude 8-9 at the Cascadia subduction zone. Each slice was obtained by driving sheetpile and a shutter plate to depths of 6-8 m. The resulting sample, as long as 8 m, had a trapezoidal...

This study is devoted to a systematic analysis of the state of stress of the central European Alps and northern Alpine foreland in Switzerland based on focal mechanisms of 138 earthquakes with magnitudes between 1 and 5. The most robust feature of the results is that the azimuth of the minimum compressive stress, S3, is generally well constrained for all data subsets and always lies in...

We perform inverse kinematic and forward dynamic models of the M 7.9 2002 Denali fault, Alaska, earthquake to shed light on the rupture process and dynamics of this event, which took place on a geometrically complex fault system in central Alaska. We use a combination of local seismic and Global Positioning System (GPS) data for our kinematic inversion and find that the slip distribution...

The 3 November 2002 Denali fault, Alaska, earthquake resulted in 341 km of surface rupture on the Susitna Glacier, Denali, and Totschunda faults. The rupture proceeded from west to east and began with a 48-km-long break on the previously unknown Susitna Glacier thrust fault. Slip on this thrust averaged about 4 m (Crone et al., 2004). Next came the principal surface break, along 226 km...