Publications

Hydrothermal alteration can create low‐permeability zones, potentially resulting in elevated pore‐fluid pressures, within a volcanic edifice. Strength reduction by rock alteration and high pore‐fluid pressures have been suggested as a mechanism for edifice flank instability. Here we combine numerical models of multiphase heat transport and groundwater flow with a slope‐stability code...

The U.S. Geological Survey tested the utility of imaging spectroscopy (also referred to as hyperspectral remote sensing) as an aid to regional mineral exploration efforts in remote parts of Alaska. Airborne imaging spectrometer data were collected in 2014 over unmined porphyry Cu deposits in the eastern Alaska Range using the HyMap™ sensor. Maps of the distributions of predominant...

This report describes procedures used in the Geology, Geophysics, and Geochemistry Science Center of the U.S. Geological Survey in Denver, Colorado, to determine the stable-isotope ratios 13C/12C, 15N/14N, and 34S/32S in solid materials. The procedures use elemental analyzers connected directly to gas-source isotope-ratio mass spectrometers. A different elemental–analyzer–mass...

Solving issues of intersource discrimination in archaeological obsidian is a recurring problem in geoarchaeological investigation, particularly since the number of known sources of archaeological obsidian worldwide has grown nearly exponentially in the last few decades, and the complexity of archaeological questions asked has grown equally so. These two parallel aspects of archaeological

Determining groundwater discharge to streams using dissolved gases is known to be useful over a wide range of streamflow rates but the suitability of dissolved gas methods to determine discharge rates in high gradient mountain streams has not been sufficiently tested, even though headwater streams are critical as ecological habitats and water resources. The aim of this study is to test...

The Aliabad-Khanchy epithermal base metal deposit is located in the Tarom-Hashtjin metallogenic belt (THMB) of northwest Iran. The mineralization occurs as Cu-bearing brecciated quartz veins hosted by Eocene volcanic and volcaniclastic rocks of the Karaj Formation. Ore formation can be divided into five stages, with most ore minerals, such as pyrite and chalcopyrite being formed in the...

PDEPTH is an interactive, graphical computer program used to construct interpreted geological source models for observed potential-field geophysical profile data. The current version of PDEPTH has been adapted to the Windows platform from an earlier DOS-based version. The input total-field magnetic anomaly and vertical gravity anomaly profiles can be filtered to produce derivative...

No abstract available.

The distribution and partitioning of elements in igneous rocks is well established for various melt –(fluid) –solid pairs and provides important insights into the petrogenesis of these rocks. Studies of the partitioning behavior of elements under metamorphic conditions are scarce and commonly focus on high-grade metamorphic facies. Little is known about the partitioning behavior of...

The U.S. Geological Survey estimates a mean of 40 million pounds of in-place uranium oxide (U3O8) remaining as potential undiscovered resources in the Southern High Plains region of Texas, New Mexico, and Oklahoma. This estimate used a geology-based assessment method specific to calcrete uranium deposits.

This map is a compilation of aeromagnetic surveys over Yukon and eastern Alaska. Aeromagnetic surveys measure the total intensity of the earth's magnetic field. The field was measured by a magnetometer aboard an aircraft flown in parallel lines spaced at 200 m to 10000 m across the map area. The magnetic field reflects magnetic properties of bedrock and provides qualitative and...

Vanadium is used primarily in the production of steel alloys; as a catalyst for the chemical industry; in the making of ceramics, glasses, and pigments; and in vanadium redox-flow batteries (VRBs) for large-scale storage of electricity. World vanadium resources in 2012 were estimated to be 63 million metric tons, which include about 14 million metric tons of reserves. The majority of the...