Conference Papers

Two large floods, 3 and 4 times the estimated 100-year peak discharge, occurred in 1986 and 1991 at a timber-pile bridge over Razor Creek in Montana. A bridge section surveyed after the 1991 flood was compared with a 1955 design section and showed total scour of 0.85 m at the left abutment, 2.23 m at the right abutment, and 0. 94 m at the pile bents. Calculated total scour based on...

A program was developed to extract hydraulic information required for bridge-scour computations, from the Water-Surface Profile computation model (WSPRO). The program is written in compiled BASIC and is menu driven. Using only ground points, the program can compute average ground elevation, cross-sectional area below a specified datum, or create a Drawing Exchange Format (DXF) fie of...

No abstract available

The BASS current meter can measure currents down to the millimeter per second range. Due to the dependence of zero offset on pressure, determining a sensor referenced velocity requires accurate in situ zeroing of the meter. Previously, flow was restricted during calibration by placing plastic bags around the acoustic volume. In this paper, bacterial grade and carrageenan agars are used...

Rock-CO2-gas analyses in test hole USW UZ-1 at Yucca Mountain indicate that gas movement in the unsaturated zone is likely through a dry-fracture system with little porewater or caliche-calcite interaction. This is because near-surface ??13C values are of biogenic origin and have changed little throughout the total depth. Post-bomb 14C activity is observed to the depth of about 12 m. An...

Three-dimensional (3-D) hydrogeologic modeling of the complex geology of the Death Valley region requires the application of a number of Geoscientific Information System (GSIS) techniques. This study, funded by United States Department of Energy as a part of the Yucca Mountain Project, focuses on an area of approximately 100,000 square kilometers (three degrees of latitude by three...

The cleat system developed in low-rank (mean viltrinite reflectance of 0.43 to 0.5 percent) coal beds in the Upper Cretaceous Mesaverde Formation was studied in outcrop and in coreholes drilled for coalbed methane evaluation near Pilot Butte in the central part of the Wind River Reservation. Cleats are the principal permeability pathway for fluids in coal beds. As a result, coalbed gas...

The environments of deposition of the uppermost part of the Cody Shale and the Mesaverde and Meeteetse Formations of Late Cretaceous age were studied on outcrop in the Shotgun Butte area in the north-central part of the Wind River Reservation. A shoreface sandstone occurs in the lower part of the Mesaverde Formation at all localities studied, and is directly overlain by a coaly interval

Analytical and numerical solutions are employed to examine the concentration history of a dissolved substance in water pumped from a leaky aquifer. Many aquifer systems are characterized by stratification, for example, a sandy layer overlain by a clay layer. To obtain information about separate hydrogeologic units, aquifer pumping tests are often conducted with a well penetrating only...

A steady-state solution for heat transfer from an isothermal, spherical magma chamber, with an imposed regional geothermal gradient far from the chamber, is developed. The extensive published heat-flow data set for Mount Hood, Oregon, is dominated by conductive heat transfer in the deeper parts of most drill holes and provides an ideal application of such a model. Magma-chamber volumes...

As with hydrothermal systems, the western U.S has higher HDR potential overall than the eastern U.S. because geothermal gradients on average are higher in the west. Nevertheless, some attractive exploration targets occur in the eastern U.S. The most favorable target in the eastern U.S. (defined here to include the Great Plains province) is one in which the heat flow from the basement...

This paper aims to assess the validity of the generalized viscoplastic fluid (GVF) model in the light of both the classical relative-viscosity versus concentration relation and the dimensionless stress versus shear-rate squared relations based on kinetic theory, thereby addressing how to evaluate the rheological parameters of the GVF model using Bagnold's data.