Publications

No abstract available.

We calculate a density model of the lithosphere of the southwestern United States through an integrated analysis of gravity, seismic refraction, drill hole, and geological data. Deviations from the average upper mantle density are as much as ?? 3%. A comparison with tomographic images of seismic velocities indicates that a substantial part (>50%) of these density variations is due to...

The U.S. Geological Survey (USGS), as part of a program to acquire seismic velocity data at locations of strong-ground motion in earthquakes (e.g., Gibbs et al., 2000), has investigated thirteen additional sites in the Southern California region. Of the thirteen sites, twelve are in the vicinity of Whittier, California, and one is located in San Bernardino, California. Several...

The seismic hazard and earthquake occurrence rates in Hawaii are locally as high as that near the most hazardous faults elsewhere in the United States. We have generated maps of peak ground acceleration (PGA) and spectral acceleration (SA) (at 0.2, 0.3 and 1.0 sec, 5% critical damping) at 2% and 10% exceedance probabilities in 50 years. The highest hazard is on the south side of Hawaii...

Dikes and irregular intrusive bodies of distinctive Oligocene biotite dacite and serially related hornblende latite and felsite occur widely in the central and eastern San Gabriel Mountains, southern California, and are related to the Telegraph Peak granodiorite pluton. Identical dacite is locally present beneath Middle Miocene Topanga Group Glendora Volcanics at the northeastern edge of...

Three-dimensional velocity models for the basins along the coast of Washington and in Puget Lowland provide a means for better understanding the lateral variations in strong ground motions recorded there. We have compiled 16 sonic and 18 density logs from 22 oil test wells to help us determine the geometry and physical properties of the Cenozoic basins along coastal Washington. The depth...

HypoDD is a Fortran computer program package for relocating earthquakes with the double-difference algorithm of Waldhauser and Ellsworth (2000). This document provides a brief introduction into how to run and use the programs ph2dt and hypoDD to compute double-difference (DD) hypocenter locations. It gives a short overview of the DD technique, discusses the data preprocessing using ph2dt...

The Los Angeles Region Seismic Experiment (LARSE) is a joint project of the U.S. Geological Survey (USGS) and the Southern California Earthquake Center (SCEC). The purpose of this project is to produce seismic images of the subsurface of the Los Angeles region down to the depths at which earthquakes occur, and deeper, in order to remedy a deficit in our knowledge of the deep structure of...

We use the energy-to-moment ratio, as introduced by Newman and Okal [1998] to examine the source characteristics of normal-faulting intraslab earthquakes, compared to nearby interplate thrust events, based on recent case studies in central Chile and southeastern Mexico. In Chile, we find that the 1997 intraslab event had an exceptionally large E/M0 ratio, 30 times greater than the nearby

In the past decade, Earth scientists have recognized the seismic hazards that crustal faults and sedimentary basins pose to Seattle, Washington (Figure 1). In 1998, the US. Geological Survey and its collaborators initiated a series of urban seismic studies of the upper crust to better map seismogenic structures and sedimentary basins in the Puget Lowland. These studies are called the...

At a marsh on the hanging wall of the Seattle fault, fossil brackish water diatom and plant seed assemblages show that the marsh lay near sea level between ∼7500 and 1000 cal yr B.P. This marsh is uniquely situated for recording environmental changes associated with past earthquakes on the Seattle fault. Since 7500 cal yr B.P., changes in fossil diatoms and seeds record several rapid...

The purpose of this report is to provide information on how and why we deploy seismic instruments in and around building structures. The recorded response data from buildings and other instrumented structures can be and are being primarily used to facilitate necessary studies to improve building codes and therefore reduce losses of life and property during damaging earthquakes. Other...