Publications

Steam-enhanced remediation (SER) has been successfully used to remove DNAPL and LNAPL contaminants in porous media. Between August and November 2002, SER was tested in fractured limestone at the former Loring Air Force Base, in Maine, USA. During the SER investigation, the U.S. Geological Survey conducted a series of borehole radar surveys to evaluate the effectiveness of radar methods...

[1] Geophysical imaging has traditionally provided qualitative information about geologic structure; however, there is increasing interest in using petrophysical models to convert tomograms to quantitative estimates of hydrogeologic, mechanical, or geochemical parameters of interest (e.g., permeability, porosity, water content, and salinity). Unfortunately, petrophysical estimation based...

Boreholes drilled through contaminated zones in fractured rock create the potential for vertical movement of contaminated ground water between fractures. The usual assumption is that purging eliminates cross contamination; however, the results of a field study conducted in a trichloroethylene (TCE) plume in fractured sandstone with a mean matrix porosity of 13% demonstrates that matrix...

A leaking underground gasoline tank contaminated a crystalline bedrock aquifer in Montville, Connecticut, USA with MTBE and benzene. At the original residential bedrock supply wells, the median MTBE concentration was 165 micrograms per liter (mg/L), and the median benzene concentration was 320 mg/L. The maximum concentrations of MTBE and benzene were 4,300 mg/l and 1,700 mg/L...

Time-lapse monitoring of subsurface processes is an emerging and promising area of hydrogeophysics. The combined use of non-invasive or minimally invasive geophysical methods with hydraulic and geochemical sampling is a cost-effective approach for aquifer characterization, long-term aquifer monitoring, and remediation monitoring. Time-lapse geophysical surveys can indirectly measure time...

No abstract available.

Electrical resistivity imaging surveys widely used in many environmental and engineering studies have also been conducted in water-covered areas. Surveys in water-covered areas include conventional surveys using multi-electrode resistivity systems where part of the survey line crosses a river or stream, and surveys conducted entirely within a water-covered environment. Surveys that are...

Most surface flows to the 20-km-long Maggia Valley in Southern Switzerland are impounded and the valley is being investigated to determine environmental flow requirements. The aim of the investigation is the devel-opment of a modelling framework that simulates the dynamics of the ground-water, hydrologic, and ecologic systems. Because of the multi-scale nature of the modelling framework...

No abstract available.

Crosswell radar methods can be used to dynamically image ground-water flow and mass transport associated with tracer tests, hydraulic tests, and natural physical processes, for improved characterization of preferential flow paths and complex aquifer heterogeneity. Unfortunately, because the raypath coverage of the interwell region is limited by the borehole geometry, the tomographic...

Geophysical tomograms are used increasingly as auxiliary data for geostatistical modeling of aquifer and reservoir properties. The correlation between tomographic estimates and hydrogeologic properties is commonly based on laboratory measurements, co-located measurements at boreholes, or petrophysical models. The inferred correlation is assumed uniform throughout the interwell region...

The 3 November 2002 Denali fault, Alaska, earthquake resulted in 341 km of surface rupture on the Susitna Glacier, Denali, and Totschunda faults. The rupture proceeded from west to east and began with a 48-km-long break on the previously unknown Susitna Glacier thrust fault. Slip on this thrust averaged about 4 m (Crone et al., 2004). Next came the principal surface break, along 226 km...