Publications

Nonpoint-source contamination of water resources from triazine herbicides has been a major water-quality issue during the 1990s in the United States. To address this issue, studies of surface water, ground water, and precipitation have been carried out by the U.S. Geological Survey in the Midwestern United States. Reconnaissance studies of 147 streams were conducted to determine the...

Seven unsaturated-zone solute-transport models were tested with two data sets to select models for use by the Agricultural Chemical Team of the U.S. Geological Survey's National Water-Quality Assessment Program. The data sets were from a bromide tracer test near Merced, California, and an atrazine study in the White River Basin, Indiana. In this study the models are designated either as...

The U.S. Geological Survey, in cooperation with the New Mexico Environment Department, is investigating the pre-mining ground-water chemistry at the Molycorp molybdenum mine in the Red River Valley, New Mexico. The primary approach is to determine the processes controlling ground-water chemistry at an unmined, off-site but proximal analog. The Straight Creek catchment, chosen for this...

No abstract available.

Fe(III)-reducing isolates were recovered from two aquifers in which Fe(III) reduction is known to be important. Strain BemT was enriched from subsurface sediments collected in Bemidji, MN, USA, near a site where Fe(III) reduction is important in aromatic hydrocarbon degradation. Strains P11, P35T and P39 were isolated from the groundwater of an aquifer in Plymouth, MA, USA, in which Fe...

Red Mountain Creek, an acid mine drainage stream in southwestern Colorado, was the subject of a synoptic study conducted in August 2002. During the synoptic study, a solution containing lithium chloride was injected continuously to allow for the calculation of streamflow using the tracer-dilution method. Synoptic water-quality samples were collected from 48 stream sites and 29 inflow...

To evaluate diffusion sampling as an alternative method to monitor volatile organic compound (VOC) concentrations in ground water, concentrations in samples collected by traditional pumped-sampling methods were compared to concentrations in samples collected by diffusion-sampling methods for 89 monitoring wells at or near the Massachusetts Military Reservation, Cape Cod. Samples were...

Analyses of stable isotope profiles (d2H and d18O) in the saturated zone, combined with water-table fluctuations, gave a comprehensive picture of recharge processes in an alluvial aquifer riparian zone. At the Norman Landfill U.S. Geological Survey Toxic Substances Hydrology research site in Norman, Oklahoma, recharge to the aquifer appears to drive biodegradation, contributing fresh...

Energy is the lifeblood of our planet Earth, an essential commod- ity that powers the expanding global economy. Starting in the 1950s, oil and natural gas became the main sources of primary energy for the increasing world population, and this dominance is expected to continue for several more decades (Edwards, 1997; Energy Information Administration (EIA), 2004). In the United States...

Climate variations can play an important, if not always crucial, role in successful conjunctive management of ground water and surface water resources. This will require accurate accounting of the links between variations in climate, recharge, and withdrawal from the resource systems, accurate projection or predictions of the climate variations, and accurate simulation of the responses...

Cross-well electrical resistivity tomography (ERT) was used to monitor the migration of a saline tracer in a two-well pumping-injection experiment conducted at the Massachusetts Military Reservation in Cape Cod, Massachusetts. After injecting 2200 mg/L of sodium chloride for 9 hours, ERT data sets were collected from four wells every 6 hours for 20 days. More than 180,000 resistance...

EXTRACTOR is a program that extracts data from formatted and labeled MODFLOW head or drawdown files or from MODFLOW-GWT concentration or velocity files. The user specifies the number of rows, columns, and layers in the target data file, the desired time step or move number, and the range of rows, columns, and layers for which data should be extracted and written to a new text file. The...