Publications

Introduction Changes in the pressure or location of magma can stress or break surrounding rocks and trigger flow of nearby waters and gases, causing seismic signals, such as discrete earthquakes and tremor. These phenomena are types of seismic unrest that commonly precede eruption and can be used to forecast volcanic activity. Mass movements at the surface, including avalanches, debris...

Introduction Based on the reports of Ewert and others (2005, 2018) and Moran and others (2008), most U.S. volcanoes are currently under-monitored and are likely to remain so until the goals of the National Volcano Early Warning System are fulfilled. In addition, volcanoes determined to have low to moderate threat levels (Ewert and others 2005, 2018) could awaken suddenly and, as a result...

Introduction Unoccupied aircraft systems (UAS) increasingly support volcano monitoring and eruption response activities in the United States and abroad (James and others, 2020). Advances in UAS platforms and miniaturization of sensors over the past decade have expanded the use of this technology for a wide range of applications within volcanology (Jordan, 2019; James and others, 2020)...

Introduction Installation of instrument packages in deep (several hundred to several thousand meters) boreholes near volcanoes is relatively expensive (a few million to tens of millions of U.S. dollars), but can provide a low-noise, high-quality source of geophysical (seismic, strain, tilt, and pore pressure), physical (temperature and water level), and geochemical data. Observations...

Introduction Explosive eruptions create plumes of volcanic ash and gas that can rise more than 30,000 feet (9.1 kilometers [km]) above sea level within minutes of eruption onset. The resulting clouds disperse under prevailing winds and may cause hazardous conditions hundreds to thousands of kilometers from the volcano, including in international airspace. Rapid detection and...

Introduction Submarine volcanoes produce much of the same seismicity and eruptive activity as subaerial volcanoes and can pose hazards to society. Although they can be monitored with similar techniques and methods as described in other chapters of this volume, their submerged location brings unique challenges. This chapter addresses these challenges and provides recommendations for...

Introduction Lahars, or debris flows that originate from a volcano (Pierson and Scott, 1985; Pierson, 1995), are among the most destructive, far-reaching, and persistent hazards on stratovolcanoes. Lahars may be triggered by syneruptive rapid melting of snow and ice, lake breakouts, or heavy rains in conjunction with large eruptive columns. Alternatively, lahars can follow eruptions...

Introduction Dynamic volcanic landscapes produce various changes at the surface of volcanic edifices. For example, rising magma can induce thermal emissions, formation of ground cracks, and variations in glacier and edifice morphology; volcanic deposits from eruptions can transform the land surface with tephra fall, pyroclastic flows, lava flows and domes, and lahars; and geomorphic...

Introduction Volcanic unrest can trigger appreciable change to surface waters such as streams, springs, and volcanic lakes. Magma degassing produces gases and soluble salts that are absorbed into groundwater that feeds streams and lakes. As magma ascends, the amount of heat and degassing will increase, and so will any related geochemical and thermal signal. Subsurface magma movement can...

Introduction As magma rises through the crust, decreasing pressure conditions allow volatiles to exsolve from the magma. These volatiles then migrate upward through the crust, where they can be stored at shallower levels or escape to the atmosphere. Rising magma also heats rock masses beneath volcanic centers, causing water in shallow aquifers and hydrothermal systems to boil and release...

Introduction When magma accumulates or migrates, it can cause pressurization and related ground deformation. Characterization of surface deformation provides important constraints on the potential for future volcanic activity, especially in combination with seismic activity, gas emissions, and other indicators. A wide variety of techniques and instrument types have been applied to the...

Introduction Volcanic eruptions produce acoustic waves when volcanic gases and hot material rapidly expand in the atmosphere. Volcanic activity can produce acoustic signals with a wide range of frequencies, from very long period (>10 seconds) to audible (>20 hertz [Hz]), but the most energetic band is typically in the infrasound from 0.5 to 20 Hz. Studies of volcanic infrasound and the...