Publications

The petrology and geochemistry of 2006 eruptive products of Augustine Volcano, Alaska, have been investigated through analyses of whole-rock samples, phenocrysts, silicate melt inclusions, and matrix glasses to constrain processes of magma evolution, eruption, and degassing. Particular attention was directed toward the concentrations and geochemical relationships involving the magmatic...

Airborne surveillance of gas emissions from Augustine Volcano and other Cook Inlet volcanoes began in 1990 to identify baseline emission levels during noneruptive conditions. Gas measurements at Augustine for SO2, CO2, and H2S showed essentially no evidence of anomalous degassing through spring 2005. Neither did a measurement on May 10, 2005, right after the onset of low level seismicity...

The 2006 eruption of Augustine Volcano, Alaska, generated more than 3,500 earthquakes in a month-long time frame bracketing the most explosive period of activity. We examine two quantitative tools that, in retrospective analysis, were excellent indicators of imminent eruption. The first tool, referred to as the frequency index (FI), is based on a simple ratio of high- and low-frequency...

Augustine Volcano, the most historically active volcano in Alaska’s Cook Inlet region, again showed signs of life in April 2005. Escalating seismic unrest, ground deformation, and gas emissions culminated in an eruption from January 11 to mid-March of 2006, the fifth major eruption in 75 years. The eruption began with a series of 13 short-lived blasts over 20 days that sent pyroclastic...

Clustered earthquakes located 25 km northeast of Augustine Volcano occurred more frequently beginning about 8 months before the volcano’s explosive eruption in 2006. This increase in distal seismicity was contemporaneous with an increase in seismicity directly below the volcano’s vent. Furthermore, the distal seismicity intensified penecontemporaneously with signals in geodetic data that...

A series of 13 explosive eruptions occurred at Augustine Volcano, Alaska, from January 11–28, 2006. Each lasted 2.5 to 19 minutes and produced ash columns 3.8 to 13.5 km above mean sea level. We investigated various parameters to determine systematic trends, including durations, seismic amplitudes, frequency contents, signal characteristics, peak acoustic pressures, ash column heights...

This chapter describes a two-step technique for determining earthquake hypocenters at Augustine Volcano. The algorithm, which was originally developed in the mid-1970s, was designed both to overcome limitations in the standard earthquake-location programs available at the time and to take advantage of the detailed seismic-velocity information obtained at Augustine Volcano. Hypocenters...

Temporal changes in waveform characteristics and earthquake locations associated with the 2006 Augustine eruption and preeruptive seismicity provide constraints on eruptive processes within the edifice. Volcano-tectonic earthquakes occur within the upper 1 to 2 km at Augustine between and during eruptive cycles, and we use the Alaska Volcano Observatory hypocenter and waveform catalog...

Seismicity at Augustine Volcano in south-central Alaska was monitored continuously between 1970 and 2007. Seismic instrumentation on the volcano has varied from one to two short-period instruments in the early 1970s to a complex network comprising 8 to 10 short-period, 6 broadband, and 1 strong-motion instrument in 2006. Since seismic monitoring began, the volcano has erupted four times...

We use seismic b-values to explore physical processes during the Augustine Volcano 2005–6 preeruptive earthquake swarm. The preeruptive earthquake swarm was divided into two parts: the “long swarm,” which extended from April 30, 2005, to January 10, 2006; and the "short swarm," which started 13 hours before the onset of explosive activity on January 11, 2006. Calculations of b-value for...

Information about reported encounters of aircraft with volcanic ash clouds from 1953 through 2009 has been compiled to document the nature and scope of risks to aviation from volcanic activity. The information, gleaned from a variety of published and other sources, is presented in database and spreadsheet formats; the compilation will be updated as additional encounters occur and as new...

Volcano deformation is usually measured using satellite geodetic techniques including interferometric synthetic aperture radar (InSAR), campaign GPS, and continuous GPS. Differences in the spatial and temporal sampling of each system mean that most appropriate inversion scheme to determine the source parameters from each data set is different. Most studies either compare results from...